Go to the first, previous, next, last section, table of contents.


Prompt

indicates its readiness to read a command by printing a string called the prompt. This string is normally `()'. You can change the prompt string with the set prompt command. For instance, when debugging with , it is useful to change the prompt in one of the sessions so that you can always tell which one you are talking to.

Note: set prompt does not add a space for you after the prompt you set. This allows you to set a prompt which ends in a space or a prompt that does not.

set prompt newprompt
Directs to use newprompt as its prompt string henceforth.
show prompt
Prints a line of the form: `Gdb's prompt is: your-prompt'


Go to the first, previous, next, last section, table of contents.