Go to the first, previous, next, last section, table of contents.


TUI overview

The TUI has two display modes that can be switched while runs:

In the TUI mode, can display several text window on the terminal:

command
This window is the command window with the prompt and the outputs. The input is still managed using readline but through the TUI. The command window is always visible.
source
The source window shows the source file of the program. The current line as well as active breakpoints are displayed in this window. The current program position is shown with the `>' marker and active breakpoints are shown with `*' markers.
assembly
The assembly window shows the disassembly output of the program.
register
This window shows the processor registers. It detects when a register is changed and when this is the case, registers that have changed are highlighted.

The source, assembly and register windows are attached to the thread and the frame position. They are updated when the current thread changes, when the frame changes or when the program counter changes. These three windows are arranged by the TUI according to several layouts. The layout defines which of these three windows are visible. The following layouts are available:


Go to the first, previous, next, last section, table of contents.