Go to the first, previous, next, last section, table of contents.


Debugging programs with multiple processes

On most systems, has no special support for debugging programs which create additional processes using the fork function. When a program forks, will continue to debug the parent process and the child process will run unimpeded. If you have set a breakpoint in any code which the child then executes, the child will get a SIGTRAP signal which (unless it catches the signal) will cause it to terminate.

However, if you want to debug the child process there is a workaround which isn't too painful. Put a call to sleep in the code which the child process executes after the fork. It may be useful to sleep only if a certain environment variable is set, or a certain file exists, so that the delay need not occur when you don't want to run on the child. While the child is sleeping, use the ps program to get its process ID. Then tell (a new invocation of if you are also debugging the parent process) to attach to the child process (see section Debugging an already-running process). From that point on you can debug the child process just like any other process which you attached to.

On HP-UX (11.x and later only?), provides support for debugging programs that create additional processes using the fork or vfork function.

By default, when a program forks, will continue to debug the parent process and the child process will run unimpeded.

If you want to follow the child process instead of the parent process, use the command set follow-fork-mode.

set follow-fork-mode mode
Set the debugger response to a program call of fork or vfork. A call to fork or vfork creates a new process. The mode can be:
parent
The original process is debugged after a fork. The child process runs unimpeded. This is the default.
child
The new process is debugged after a fork. The parent process runs unimpeded.
ask
The debugger will ask for one of the above choices.
show follow-fork-mode
Display the current debugger response to a fork or vfork call.

If you ask to debug a child process and a vfork is followed by an exec, executes the new target up to the first breakpoint in the new target. If you have a breakpoint set on main in your original program, the breakpoint will also be set on the child process's main.

When a child process is spawned by vfork, you cannot debug the child or parent until an exec call completes.

If you issue a run command to after an exec call executes, the new target restarts. To restart the parent process, use the file command with the parent executable name as its argument.

You can use the catch command to make stop whenever a fork, vfork, or exec call is made. See section Setting catchpoints.


Go to the first, previous, next, last section, table of contents.