Go to the first, previous, next, last section, table of contents.


Create and Delete Tracepoints

trace
The trace command is very similar to the break command. Its argument can be a source line, a function name, or an address in the target program. See section Setting breakpoints. The trace command defines a tracepoint, which is a point in the target program where the debugger will briefly stop, collect some data, and then allow the program to continue. Setting a tracepoint or changing its commands doesn't take effect until the next tstart command; thus, you cannot change the tracepoint attributes once a trace experiment is running. Here are some examples of using the trace command:
() trace foo.c:121    // a source file and line number

() trace +2           // 2 lines forward

() trace my_function  // first source line of function

() trace *my_function // EXACT start address of function

() trace *0x2117c4    // an address
You can abbreviate trace as tr. The convenience variable $tpnum records the tracepoint number of the most recently set tracepoint.
delete tracepoint [num]
Permanently delete one or more tracepoints. With no argument, the default is to delete all tracepoints. Examples:
() delete trace 1 2 3 // remove three tracepoints

() delete trace       // remove all tracepoints
You can abbreviate this command as del tr.


Go to the first, previous, next, last section, table of contents.